Professional Laminating Systems II Series Betriebsanweisung PDF herunterladen (Seite 17)

Feeding Items into Machine

The initial feeding of an item into the machine is the most important

part of the process. If an item enters the machine on an angle, or

with wrinkles in the leading edge, the output may end up with

wrinkles. Some items are easier than others. Generally smaller and

more rigid items are the easiest. A very large, thin item is more

challenging, but should provide few problems if fed into the machine

correctly. With a little practice it is easy to feed items into the

machine properly 100% of the time.

Single items

This is the most common use, in which

single items are fed into the machine one after the other.

This example covers most of the techniques involved in

proper use of the machine.

1. Switch the machine to "Foot" mode. Do not start the

rollers turning yet.

2. Pull the paddle back to stop. This will raise paddle

leaving clearance under paddle to insert media into

machine. Paddle will raise approximately 1/8”.

Ensuring the leading edge of your document is flat is

very important, as a small wrinkle at this point may

continue through an entire document.

Lay the item flat on the feed tray and slightly stretch the

leading edge with your fingers to make it lay flat. Move the item

under the paddle and onto the rollers until it is touching the film.

Press the paddle forward and down to force contact between the

media and adhesive.

3. Once you are satisfied that the item is straight and flat, Press the

foot pedal. As the document begins feeding through the system,

lower the paddle by sliding it forward. Use control buttons on

housing or if foot pedal to advance once the media is feeding.

Do not push the item into the machine, as this will wrinkle the

leading edge; instead, allow the rollers to grip and pull in the item.

Once the item has passed through the rollers, you may stop the

machine and prepare the next item in the same

method as above. If you are only laminating one item

and need it removed from the machine, keep the motor

running until it has passed through the rollers.

Load item under the paddle, squarely to film

Pull back he paddle

Push paddle forward

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Keine Kommentare

Professional Laminating Systems II Series Betriebsanweisung Seite 17