Professional Laminating Systems II Series Spezifikationen PDF herunterladen (Seite 65)

Cleaning the Slip Ring

This procedure must be preformed if there is an erratic and sudden fluctuation in the displayed

temperature while the laminator is in operation Follow these steps and all safety precautions. This

procedure is only necessary if the temperature fluctuates when the upper roller is rotated by hand and the

roller direction is in the off position

1. Disconnect the laminator from the electrical supply and allow it to cool.

2. Gap the rollers.

3. Remove the left-hand side panel.

4. Inside the left-hand side panel protruding from the upper roller is the slip ring for the

Temperature controller.

5. Using scotch brite or a similar material, remove the carbon and oxidation build up from the slip

rings. Rotating the upper roller by hand may facilitate this process.

6. Apply rubbing pad compound. See rubbing pad compound on page 59.

Cleaning the motor

This procedure must be performed only after the slip rings have been cleaned and the displayed

temperature continues to fluctuate only while the motor is operating and the front upper roller is gapped

and stationary. This is not typical; this should only be performed as a last option.

1. Disconnect the laminator from the electrical supply

2. Remove the left side panel upper fan deflector and fan panel.

3. Remove the motor mounting screws accessible from the inside of the left frame.

4. Remove the chain and rotate the motor to access one of the brushes on the side of the drive

motor Remove one of the brushes making sure to keep track of the direction the brush is

removed.

5. Apply a very small amount of slip ring compound to the contact area of the brush.

6. Replace the brush making sure that it is replaced the same direction it was removed.

7. Replaced the motor and chain Apply mild pressure to the motor for chain tension and tighten the

motor bolts.

8. Replace the side panel, upper fan panel and fan deflector.

9. Plug the laminator in and run the motor for a few minutes on the maximum setting.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 81 82

Keine Kommentare

Professional Laminating Systems II Series Spezifikationen Seite 65