Professional Laminating Systems II Series Spezifikationen PDF herunterladen (Seite 27)

Laminator Assembly

Standard Towers with Slitters

This installation is simple; the towers are installed onto the machine side panels

using the included hardware. Distinguish the towers from left and right, the right

tower has the extra threaded hole with a ball plunger inserted. The inside face of

this right tower is distinguished by the chamfered mounting hole.

1. Install left tower using two 5/16 x ½” long, hex head bolts.

2. Install right tower (ball plunger) with the countersunk hole located toward

the front of the laminator and toward the center. Use one 5/16 x ½” long,

hex head bolt in the rear hole

Use one 5/16 x ½” long flat head Allen screw in the front hole

Take note that on the right tower the rear bolt must be oriented so that the side

of the bolt is parallel to the side of the slitter-actuating handle (see diagram

below.). Do not over tighten bolt it is better that it be looser rather than over

tightened

Correct

Notice both bolt and arm lay flush and

parallel

Incorrect,

Notice tip on bolt is preventing arm

from seating

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 38 39

Keine Kommentare

Professional Laminating Systems II Series Spezifikationen Seite 27